SparkFun Electronics 工具与耗材

SparkFun 配件 The SparkFun H3LIS331DL Triple Axis Accelerometer Breakout is a low-power high-g accelerometer with I2C and SPI interface options. Though not necessarily good at detecting minute changes the H3LIS331DL is great for grueling conditions that normal a

SparkFun 配件 This miniature straight bar load cell (sometimes called a strain gauge) can translate up to 500g of pressure (force) into an electrical signal. Each load cell is able to measure the electrical resistance that changes in response to and proportional

PCB 座及钳夹 Give your arms a rest! Stickvise holds your circuit board flat so you can solder with stability at table level. These flat PCB holders are great because your hands can rest directly on the table for fine soldering and probing. They also fit easily un

教育套件 Ethernet Kit for Teensy 4.1

SparkFun 配件 This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm center-positive male barrel jack. If you need to connect bare wires to a barrel jack on an Arduino or a development b

教育机器人套件 This vacuum pump really sucks! This pump operates at 12V and has enough suction for most small projects. We even used one to make our very own universal gripper using coffee grounds balloon and some other parts.Features:12V motor12W operation1/4" ba

SparkFun 配件 Graphic Equalizer Display Filter

SparkFun 配件 This is a 50mm long ESLOV to ESLOV cable. The ESLOV connector has five pins (one more than standard I2C) for automatically configuring the module and handling the sleeping states to boost battery life. Use this cable to connect two ESLOV boards toget

教育套件 The great thing about open source is that while SparkFun has designed our own MicroMod carrier boards that does not stop you from creating your very own MicroMod carrier board. The MicroMod DIY Carrier Kit includes five M.2 connectors (4.2mm height)

SparkFun 配件 This 2x20 pin female header is meant to allow you to extend the reach of any board with the standard 2x20 GPIO pin footprint like the Raspberry Pi Google Coral and NVIDIA Jetson. You can also solder it to Pi HATs that do not have headers on the boa

教育机器人套件 These are a pair of basic 65mm wheels with black rubber tires. These wheels are the same ones designed to fit onto DAGUs right angle gear motors utilized in the Magician Chassis and RedBot Kit. With these wheels you will be able to get almost any be

SparkFun 配件 A simple plug and play USB C to A converter (and vice-versa). This allows you to run devices and cables with the classic USB Type A connector off a device or adapter with a USB Type C port. It features up to USB 3.1 speeds.